BMW 5 Series G60 / G68 / M5 G90 / i5 Sedan (2024-2026) Clear Black Venom Custom Taillights

Black Venom Custom Taillights – G60 / G68 / M5 G90 / i5 Sedan (2024-2026)

These BMW 5 Series G60 tail lights are built for the current-generation G60 platform sedan (2024-2026) and ship as a true plug-and-play replacement for the factory LED units. Every pair starts as a genuine used BMW OEM tail light core pulled from a low-mileage donor car, refinished in-house with our signature Black Venom blackout treatment – a fully transparent clear lens paired with a deep gloss-black internal frame – and resealed at the factory joint with professional-grade automotive sealant. The result is a sharper rear-end that drops the chromed factory look while preserving the dynamic turn signature BMW invested in on the latest 5 Series, including the M5 G90.

If you have been searching for genuine BMW M5 G90 clear tail light units, a true BMW 5 Series custom taillights upgrade, or simply BMW 5 Series G60 clear tail lights you can install in a driveway, this is the set. They are hand-built, not mass-assembled, and they ship ready to bolt on with zero additional coding.

Why the Black Venom Style – and Why It Is More Than a Cosmetic Refinish

These BMW 5 Series G60 tail lights address both the cosmetic and the well-known factory issues. Most aftermarket “custom” units on the market are shell-only swaps – the buyer gets a new housing but inherits the old LED boards, which means two problems: (1) condensation builds up inside the housing over time because the factory seal is compromised by the swap, and (2) the cheap replacement boards trigger bulb-out warnings on the cluster because they do not match the OEM current draw. We solve both with our TSB-backed condense-fix workflow.

We rebuild on the original OEM cores. Every housing is a genuine BMW G60 OEM part (outer housing 63215Axxxxx / 63225Axxxxx with matching inner 63215Axxxxx / 63225Axxxxx). We do not buy aftermarket shells from China. We open the OEM unit, replace the seal with a professional-grade sealant rated for automotive lighting, refinish the chrome trim to gloss black, and reinstall the original LED boards onto fresh thermal pads. This is the same workflow BMW dealerships follow when addressing the well-documented G60 tail-light condensation complaint – we just apply it as a standard production step on every set we ship.

Built to Fix the Factory Condensation – Permanently

The G60 platform is known for rear-lamp condensation. Moisture enters through the factory seal and collects on the inside of the lens, leaving a permanent fog that no amount of rear-housing drilling will fully solve. Every pair of our BMW 5 Series Black Venom taillights addresses this directly: new professional-grade sealant reseal, fresh thermal pads on every LED board, and a vacuum-style reseal so the housing holds positive pressure against future moisture intrusion. When you buy a set from us, you are not just buying a style upgrade – you are buying a permanent fix for the factory condensation issue that BMW service centres document every winter on the new 5 Series, including the all-electric i5 and the M5 G90 plug-in hybrid.

True Plug-and-Play – No Coding, No ISTA, No Bimmercode

Because we re-use the OEM LED driver boards, the rear body domain controller (FEM-BD / G60 SAM) recognises the lamps as factory units the moment they are connected. There is no ISTA coding, no Bimmercode pass-through, and no aftermarket CAN-BUS module required. The BMW 5 Series G60 clear tail lights drop straight into the factory connectors, and the existing wiring is reused. A first-time DIYer can complete the swap in about 30-45 minutes per side with a T20 Torx and a panel tool – that is the entire job. This holds true across every variant on the platform, including the all-electric BMW i5 clear tail light pair (eDrive40 and M60 xDrive) and the 727 hp BMW M5 G90 clear tail light set.

What You Get in the Box

• 1 x Pair of BMW 5 Series G60 tail lights – driver (left) and passenger (right) outer housings, Black Venom finish, clear lens, gloss black internal trim
• 1 x Pair of matching inner LED housings (trunk-lid units), Black Venom finish, ready to plug in
• Pre-installed OEM LED driver boards on fresh thermal pads
• Professional-grade sealant reseal on every housing (no butyl, no shortcut)
• Mounting hardware and gasket pre-fitted – no extra parts needed
• Printed install guide + 90-day warranty from delivery date

Fitment – Read This Before You Order

This BMW 5 Series G60 tail lights set fits the current-generation G60 platform sedan (2024-2026), including 520i, 530i, 540i xDrive, 530e, 550e xDrive, i5 eDrive40, i5 M60 xDrive, M5 G90, and the long-wheelbase G68 sold in China. It is not compatible with the previous-generation G30 / G31 5 Series (2017-2023) – that generation uses different outer part numbers and a different light signature. It is also not compatible with the Touring / estate (G61) – the Touring uses longer inner trunk-lid housings. Sedan only. If you are not sure which body style or generation you have, send us the last 8 digits of your VIN before ordering and we will confirm fitment.

Handmade Disclaimer – Important to Read

Every pair of BMW 5 Series custom taillights we build here is handcrafted on a per-order basis using genuine OEM cores. Each BMW 5 Series G60 tail lights set is individually tested before dispatch. Because each unit is built by hand, small variations between individual pieces (lens clarity, trim finish depth, gasket seating) are normal and expected – they are not defects and are not grounds for refund or return under our handmade-custom policy. Production time is typically 5-8 business days before dispatch. We will not ship a set we are not proud to put our name on.

Each item is handcrafted from genuine used OEM cores and is not a genuine BMW part. BMW, BMW 5 Series, M5, i5, and the roundel logo are registered trademarks of Bayerische Motoren Werke AG (BMW AG). This product is not endorsed by or affiliated with BMW AG.